What is the general inspection checklist for Mechanical Rough-Ins?
  • Are all ducts ran and terminated where it will permanently go? 
  • Are ducts supported every 8ft? 
  • Is there less than .5” of fall per foot between supports? 
  • Are NO framed cavities being used for supply or return air? 
  • Is there at least 1 supply vent per room? 
  • Are all exhausts terminated at least 3ft away from openings into buildings 
  • Are all duct joints, seams, and connections sealed by an approved method? 
  • Are all framed duct runs fireblocked? 
  • Is there exhaust ducts in each bedroom and is it terminated to the outside? 

Show All Answers

1. Do I need an inspection?
2. Do I need to be present for every inspection?
3. What is the general inspection checklist for Erosion and Sediment Control (E&S)?
4. What is the general inspection checklist for Footings? (Can be inspected by a 3rd Party.)
5. What is the general inspection checklist for Foundations? (Can be inspected by a 3rd Party.)
6. What is the general inspection checklist for Groundworks? (Can be inspected by a 3rd party, but must be approved by the Building Official.)
7. What is the general inspection checklist for Slabs? (Can be inspected by a 3rd party.)
8. What is the general inspection checklist for Drain Tile/Waterproofing? (Can be inspected by a 3rd party.)
9. What is the general inspection checklist for Framing? (Framing and all Rough-In Inspections can be inspected at the same time.)
10. What is the general inspection checklist for Plumbing Rough-Ins?
11. What is the general inspection checklist for Electrical Rough-Ins?
12. What is the general inspection checklist for Mechanical Rough-Ins?
13. What is the general inspection checklist for Permanent Service?
14. What is the general inspection checklist for Insulation?
15. What is the general inspection checklist for Building Final?
16. What is the general inspection checklist for Deck Framing?
17. What is the general inspection checklist for Deck Final?